Telescoping Fiberglass Flagpole for Flutter Flags

Telescoping Fiberglass Flagpole for Flutter Flags

SKU: acoPoleFlutterTelescpFglass6-15
$84.00
Made in the USA
$9 Flat Shipping Rate
Quality Guarantee

Frequently Bought Together

Please choose options for all selected products

  • Choose Options

Telescoping White Fiberglass Flagpoles 

Sizes:  6-15' or 8-21'

Dimensions: Top Diameter 3/4" / Bottom Diameter 1-1/4"

These telescoping fiberglass flagpoles sway in the breeze producing a dramatic, attention-getting display.  PVC ground sleeve included for permanent ground installation.  Reinforced bottom for extra durability.  

1 Review Write a Review

  • 4
    4 maybe 5 stars - we'll see how it goes when the wind really gets strong

    Posted by Michele on 12th Jun 2015

    We live in an area where we have wind constantly, and sometimes very strong wind. Short of getting a $500 commercial pole, I was told this one would hold up - up to 120 mph winds - and ours is usually not over 90 mph.

    We have 3 flags on it, a 3x5 American flag and 2- 2x3 flags, Gadsden and POW/MIA. With the 3 flags it does bend the pole a bit when the wind is blowing, and so we do not have the pole extended to it's full height and this is Spring/Summer - and this time of year the wind is not too bad.

    The instructions say to dig a hold 24-36 inches in diameter, and 2' deep. My hubby followed directions and we had to use 9-80 lb bags of concrete to fill that hole. Well, at least the wind will not blow it out of the ground.

    Anyway, I am a little concerned that a higher wind could snap the pole, and we may have to remove one of the flags if the wind gets too strong, but if the pole does not snap, I'll revise my rating to 5 stars.

Back to Top